![Kathrein EXD 1532 Скачать руководство пользователя страница 21](http://html2.mh-extra.com/html/kathrein/exd-1532/exd-1532_user-manual_3611745021.webp)
9 / 12
The following channels are additionally available by running a manual search:
Nickelodeon Germany
Nicktoons Germany
VIVA
Comedy Central
3sat HD
KiKA HD
ZDFinfo HD
Eurosport Germany
EuroNews
RTL Austria
VOX Austria
Super RTL HD*
RTL Nitro HD*
RTL HD Austria* VOX HD Austria*
* You need a valid HD+ subscription for each receiver to receive these channels.
Bear in mind that in static mode your multi-switch behaves similar to a headend and that
the transponders can no longer be selected by means of a single-cable command from
your TV or receiver.
The transponders/channels are present “statically” at the output. The multi-switch always
makes them available without control signals and receiver voltage. This enables a satellite
distribution with the same degrees of freedom as a single-cable unit. Depending on the
building’s structure, the distribution can be a star-type, tree-type or mixed distribution.
The multi-switch does not require remote feeding. Only the distribution losses and level
ratios must be observed. As there is no assignment to a user band, a virtually unlimited
number of receivers can be connected.
If you are not satisfi ed with the pre-set channel selection, there are optimised channel
lists for Austria, Switzerland or Sky, for example.
These channel lists can be installed in the multi-switch using the SWP 50 programming
device in connection with the free
Kathrein Userband Editor
software. For more information
on the programming device and the software go to
www.kathrein-ds.com
.
After programming the multi-switch, it is imperative to run a blind scan on the receiver so
that the available channels can be found.
User Band Editor
NOTE
For systems with static mode, the receivers must not be in single-cable
mode. For reception, set your device to “DiSEqC 1.0” or “simple LNB”, for
example. If possible and if supported by your device, run a complete search
(blind scan). All receivable channels will then be listed.
NOTE
If the EXD 2532 is used in static mode, an NCF 18 must be connected for local
power supply!