Kathrein CAR 150 WiFi Duo, Инструкция по эксплуатации

Страница: 8 / 20

8 / 20
Mounting the external antenna ...
... using the Kathrein roof gland
1. Remove the pre-assembled nut (M27) and the two
washers.
1. Clean and mark the installation site.
2. Drill a ∅ 38 mm hole in the roof according to the
marking.
3. Deburr and clean the drill hole.
4. Feed the antenna cables through the roof gland
supplied (observe the correct position!) and screw
them onto the antenna thread until just before the
stop. Screwing on the roof duct fi rst makes it easier to
centre it in the roof hole.
5. Run the cables from the outside through the roof hole
to the inside.
6. Remove the backing from the adhesive pad of the
antenna.
7. Now screw the roof gland onto the thread of the
antenna as far as it will go.
8. Position the antenna correctly and press it down well
(the entire surface must have contact).
9. Run the antenna cable into the interior through the
knurled nut provided.
10. Screw the knurled nut onto the roof gland (hand-
tighten) to secure the antenna.
Auslieferungszustand:
Mutter und Scheiben vormontiert
Trägerfolie
ø38