3
2
Insert each boom cymbal arm into pillar(L1)and pillar(R1,R2).
Remove wing nut and felt washer from cymbal tilter.
Place cymbal pad on tilter assembly.
Re-attach the felt washer and wing nut. Tighten wing nut.
Note: Cymbals are arranged as follows:
12" crash on left-side boom arm, 14" ride on right-sideboom arm,
12” crash2 on right-side boom arm.
1
Loosen the wing screw on the clamp
Insert the drum module to the clamp
Tighten the wing screw on the clamp
Loosen L-rod wing nuts on drum pad clamp.
Insert textured plastic end of L-rod into tom clamp and tighten wing nuts.
Repeat for each drum pad clamp.
Loosen wing nut on pad.
Attach pads to L-rods and tighten wing nuts. Repeat for each pad.
1
2
3
4
Attaching pads to rack
Attaching module
Attaching cymbals
Bass drum and Hi-Hat pedal
1
2
3
Place the kick pad on the floor in the center of rack.
Attach your kick pedal to the kick pad.
Place the
on the floor on your left side.
Please connect the clearly marked cables from the pads to the correct inputs on the drum module, and you are ready to play!
Hi-Hat stand with actuator and pad attached
1
2
3
Wing Nut
Felt Washer
Wing Nut
Felt Washer
1
2
14"
12"
12"
11”
11”
11”
11”
1
Loosen the wing screw
2
Insert the drum module
3
Tighten the wing screw
12" Cymbal Pad
12" Cymbal Pad
14”
Cymbal Pad
Ride
11”
Pad
11” Pad
11” Pad
11” Pad
Kt4 Drum module
Kick pad
kick pedal(option)
1
Hi-Hat Stand
12" Hi-Hat Pad
Pillar(L1)
Pillar(R1)
Pillar(R2)
0
5
25
75
95
100
KMC_KT4__ Setup Manual_003_150917
2015
9
17
10:13:32
