ver 1.0
Peel off backing tape and
fix into position.
Ensure that surface is clean and dry by
using an isopropol alcohol.
Suitable for mounting on
normally flammable surfaces
Cut strip to length at indicated intervals
(every 167mm) using a sharp knife or
scissors . Ensure care is taken to avoid
damage to terminals.
Contents
Connect strip to strip controller driver.
Fix controller to surface with screws.
x20
1
2
Apply silicone to end of strip.
7
4
5
RESET
INPUT
OUTPUT
Connect strip to driver.
Fix driver to surface with screws.
8
INSTALLATION
x2
Secure strip by fastening
saddles to surface.
6
3
Press End Cap onto end of strip.
Ensure full coverage to
maintain IP54 rating.
