9
8
INSTallaTION - RONDa / PETRa
5
Once the works on electricity,
plumbing and tiles have been
finished, insert the wall rosette
through the soap dispenser
base, and cut the temporary soap
dispenser base cover.
Fix the soap dispenser spout by
inserting the nipple into the soap
dispenser base and tighten the
screw.
Pull the four way connector and the
power supply connector out of the
soap dispenser base, and lead it
through the corrugated tube.
INSTallaTION - RONDa / PETRa
Step 2 – CONNeCtINg the pOWer SOurCe
1
Remove the protective sticker
covering the sensor. Keep away from
the sensor range and check that no
objects are in front of the sensor.
2
Connect the soap pump
connector to the matching
connector from the sensor.
Please note that since the
connector is waterproof, some
friction might apply.
O-RING VISIBLE –
NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE –
CONNECTED PROPERLY
ImpOrtaNt:
the 4 contacts connector should be connected properly so that the white
o-ring is not visible and a clicking sound is heard.
pay atteNtION:
if the 4 contacts connectors will not be connected properly, the pump
will work continuously.
2a
For battery versions: install the
battery box on the wall underneath
the sink and connect the battery
connector
FROM THE SOAP DISPENSER
TO THE bATTERY bOx
2b
For transformer versions: plug the
transformer into the electricity socket
and connect the transformer connector
FROM THE TRANSFORMER
TO THE SOAP DISPENSER
3
Wait about 10 seconds before
you put your hands within the
sensor range to avoid entering the
adjustment mode.
10
SECONDS
AbOuT
