LEDC11 MANUAL
4
MOUNTING INSTRUCTIONS
1.
Attach the bracket (H) to the light fixture (C) by fitting the head of the 10-32 x 1/2’’ hex screw (I) into the
tabs on each side of the fixture. Place one bracket O-ring (G), one #10 lock washer (F), and one thumb
nut (E) on each #10 screw outside the bracket. Tighten the thumb screws on each side hand tight only.
Repeat this step for all fixtures.
2.
(Optional) If you want to use one of the color choices instead of the standard soft white light, peel the
protective lining from both sides of the colored lens (B) of your choice. Place the lens inside the lens cap
(A) making sure the 3 flaps are holding the lens in place. Repeat this step for all lens caps. Continue to
Step 3.
No gap
Flaps behind lens
G
C
F
E
H
A
Back to Contents