Kasco WaterGlow LED3S19, Руководство пользователя

Страница: 4 / 12

4
protected outlet and timer.
Instructions for mounting LED3S19 on models:
8400VFX, 800JF, 2.3VFX, 2.3JF, 3.1JF, 3.3JF,
5.1JF, 5.3JF, 5.1VFX, 5.3VFX, 7.3JF
1. Install the mounting brackets to the light fixtures
as shown using ¼” lock washers and ¼” x ½” bolts.
Hand tighten only at this time.
Fig 8
Important Note: Installation of the LED light fixtures
on the above listed aerating fountain units with the
mounting brackets oriented as shown will ensure
proper submersion of the light fixtures. Each fixture
must be partially submerged in order for lights to
operate properly. Other applications for these fixtures
must provide at least the same submersion to properly
cool the fixture. Operating the fixtures out of water
will damage the LED and void warranty.
2. Insert the ¼” x 1” bolt into the light mounting
bracket. Align the bracket to the float bracket by
placing the bolt through the light mounting hole
(mounting bracket is on top of the float bracket) as
shown in Fig.9
Fig 9
3. Install the ¼” Flat Washer, ¼” Lock Washer and
5. Install the ¼” Flat Washer, ¼” Lock Washer and
¼” Nut against the underside of the float tab as shown
in Fig. 5. Tighten the nut until snug using the 7/16”
wrench.
Fig 5
flat washer
lock washer
1/4” nut
6. Adjust the angle of the light as desired and tighten
the ¼” x ½” bolts on the sides of the mounting bracket
until snug. For more uniform illumination, it is best to
have all three fixtures at the same angle.
7. Repeat steps 1 through 4 for the remaining fixtures.
Assembled light fixtures are pictured in Fig. 6. Note
the orientation of the lights and mounting brackets.
Fig 6
8. Using the cable ties, tie each fixture cord to bottom
leg of mounting brackets using the holes provided.
The will act as a strain relief and will keep the cord
from being damaged by the fountain and balance the
unit properly. Next, cable tie the main power cord to
the float as shown in Fig. 7.
Fig 7
9. Upon installation of the assembled unit, connect
your LED light kit to your field installed GFCI