RGB4C5 UNIVERSAL LIGHTING
MANUAL
884103 / 2021.1.1
5
Hardware is provided for basic installation. Check your installation to ensure you have the correct hardware. Additional hardware may
be included, or you may need to purchase it if your installation varies from the diagrams below�
For vertical bracket mounting, use the hard-
ware shown in Figure 6 to fasten the two
brackets together. Then use your existing float
screws through the slot in the Universal brack-
et to secure it�
3. Use 1/4”-20 x 3/4” hex screws (O), flat washers (I), lock
washers (J), and hex nut (K) as shown in Figure 5 to se
-
cure each Composite light brackets (F) to the Universal
mounting brackets (M).
Use 1/4”-20 x 3/4” hex screws (Q), fender washers (P),
lock washers (J), and hex nut (K) to secure the Univer
-
sal bracket to the float.
•
Note: Composite light bracket (H) needs to be
flipped upside down for horizontal mounting.
Fig. 5
Fig. 6
4�
Repeat for remaining fixtures, spacing evenly around the float. Adjust the angle of the lights using thumb nuts if desired, being
sure to use the same angle for all fixtures. Cable ties can be used to attach the fixture cords to float, decrease play, and ensure
protection. Cable-tie the light kit power cord to the float opposite the fountain power cord for balance and to prevent damage from
the fountain. Remember: RGBC5 fixtures MUST be properly submerged (approximately halfway) to avoid overheating.
Back to Contents
