Kartsana BRAVA, Инструкция по эксплуатации

Страница: 7 / 36

OPERATING AND HANDLING
THE BRAVA POWER STRETCHER
4
2.2.- Operating and handling the stretcher
2.2.1.-Installing the battery
The first step when working with Brava is to install the two 24 V. batteries which
power the system. To do this, we open the rear black cover and place the batteries
opposite their housings at the back of the stretcher and push until it locks.
To remove each of the batteries, press the small trigger located on the lower left
hand side and pull carefully. Both batteries work independently of each other. The
system will run down the first battery and then start to work with the second.
Each battery life under normal circumstances (from 80 to 120 kg load) should be
about 20 cycles. When a battery approaches discharge the system will use the
second battery.
Note: The front part of the stretcher corresponds to the head part.
Note: Batteries are delivered with a minimum charge. Prior to operating the bed we
charge the batteries with the charger supplied, until the LED turns green it. After that
we can work normally.
Trigger to
remove battery