19
SUGGESTION:
●
Please kindly be advised that the pelvic belt should be fitted tightly
around the user's pelvis and be tightened until you can just get one
finger through between the pelvic belt and the user. Kindly check the
pelvic belt position is fitted to the place as we recommend. If it is not
able to be this way, please consult your supplier.
4.11.2 Pelvic belt Adjustment
4.11.2.1 Make sure that the total length of the pelvic belt is sufficient.
4.11.2.2 Adjust the length of the pelvic belt through the buckle of both ends.
(Figure 4.46)
4.11.2.3 Pull the two parts of belt tight. (Figure 4.47)
4.11.2.4 Push the buckle of both ends to the plastic clip so that the pelvic
belt will not slip out of the position.
Figure 4.46
Figure 4.47
Figure 4.48
4.11.3 Pelvic belt Fitting
4.11.3.1 Loosen the screw on the back bracket..
4.11.3.2 Fit the pelvic belt. Use the screw you removed and retighten.(Figure
4.48)
4.11.4 Maintenance
The pelvic belt is made from 100% polyester fibers and the clasp is made
from plastic. It does not require any maintenance but should be inspected
every month to ensure that the edges are not frayed and weekly to make
sure that it correctly fits the user.
CAUTION:
●
Maintenance: There is no specific maintenance for the pelvic belt;
however, please check if the edge of the pelvic belt is worn or torn
before you use it. Meanwhile, please adjust the pelvic belt properly to
fit the user. If the pelvic belt is damaged, please replace a new one
immediately.
