Assembly Instructions – 4A95M
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 10
Step 7 – Install Handle
Remove the 5/16” flanged head screws, 5/16” washers, and 5/16” lock
nuts from rear bow as circled below.
Apply sealant to swaged ends of handles.
Use removed hardware to bolt handles into position as shown.
TIGHTEN.
Step 8 – Assemble Ladder Hooks
Install the ladder hooks on the
previously installed ladder hook
base using 1/4" x 1” hex head
bolts, 1/4" lock washers, and
1/4" flat washers in the desired
locations. The location is
dependent on the size of the
ladder used. Adjust so the ladder
hook fits the ladder as tight as
possible.
TIGHTEN.
Repeat for remaining 3 ladder
hook locations.
