
IPV20 TECHNICAL REFERENCE & INSTALLATION GUIDE
5
2. After connecting the Power, please check if the Power LED on the front panel lights
up. A lit LED indicates that the power is properly connected. If the LED does not light
up then please repeat all of the steps, from step one to step three.
IPV20 EXCHANGE WALL INSTALLATION:
Take the following steps to install the box to a wall:
1. Use IPV20 Exchange "Installation Illustration" to determine the location of
the terminal on the wall and to mark the location of the holes. The length of the
power adapter cable must be considered when determining installation location.
Installation Template
2. Insert pegs inside the holes drilled on the wall and install the screws into
these pegs so that 4 mm from the head side of the screws will remain
unscrewed.
3. Figure above device hang on the wall by hitting hanger holes and screw
heads.
Note: There is no need to remove the electronic card from the box prior to installing
the box on the wall. However, should it be necessary to remove the card from the box
for any reason whatsoever, five screws illustrated in Figure must be removed in order
to remove the card.
Содержание IPV20
Страница 1: ...IPV20 TECHNICAL REFERENCE INSTALLATION GUIDE 13 06 2012...
Страница 13: ...IPV20 TECHNICAL REFERENCE INSTALLATION GUIDE 6...
Страница 26: ......