16
17
5. Carrying out a measurement
5. Carrying out a measurement
2. Press the time button to set the hours—the hours display flashes and press the
“MEMORY” button allows you to set the alarm hour. To confirm, press the TIME
button.
3. The minute display will now flash . the minutes can be set using
the “MEMORY” button. To confirm, press the TIME button again
.
4. The bell symbol will now flash. Use the “MEMORY” button to select whether the
alarm time is to be active (bell) or inactive (crossed-out bell). To confirm, press
the TIME button.
To set a second alarm time, proceed as above but if the “1” flashes, press the “MEMORY” button to select
“2” and confirm with the TIME button.
•
an active alarm time is indicated by the bell symbol in the display
•
the alarm sounds at the set time every day.
•
To switch-off the alarm when is sounding, press ON/OFF button
•
To permanently switch-off the alarm, proceed as above (step 1~4), and select the crossed-out bell symbol. This will then
disappear from the display.
•
The alarm time must be re-entered each time the battery are replaced.
5.7. Memory full
Pay attention that the maximum memory capacity is not exceeded. When the memory is full, the old values
are automatically Overwritten with new ones. When memory is full , the display shown 1 second as follows
to remind you “ memory full “
5.8. Memory– cancellation of all measurements Attention!
Before you delete all readings stored in the memory, make sure you will not need refer to the readings at
a later date. Keeping a written record is prudent and may provide additional information for your doctor’s
visit. In order to delete all stored readings, depress the MEMORY button for at least 5 seconds, the display will
show the symbol «CL» and then release the button . to permanently clear the memory, Press the MEMORY
button while «CL» is flashing. 3 short beep sounds will be heard to indicate deletion of stored readings.
5.9 Setting the medication reminder
This instrument allows you to set two alarm times at which an alarm signal will then be triggered. This can be an useful and , for
instance as a reminder to take medication or to remind you to take your blood pressure at the same time each day.
1. To set an alarm time, press the“ TIME” button ( the instrument must have been switched off beforehand)
and immediately afterwards the “MEMORY” button and hold both down until the bell symbol appears in the
bottom left of the display. Then release both buttons. The flashing “1” in the display indicates that the first
alarm time can now be set .
