17
KMR 1250 B, LPG, D
Troubleshooting Information
Check voltage on starter solenoid
–
Hold ignition switch in position II.
–
Measure the voltage between solenoid ter-
minal and vehicle ground.
–
If the meter fails to indicate a voltage, wiring
must be checked for possible defect.
–
If a voltage is present but starter fails to turn,
starter is defective and must be replaced.
Note:
The connecting wiring for the starter sole-
noid are not shown in electrical diagram.
Checking voltage on starter motor M1
Checking voltage on starter solenoid
Check starter M1
–
Hold ignition switch in position II.
–
If a voltage is present but starter fails to turn,
starter is defective and must be replaced.
Starter Fails to Turn Engine
V
SW
V
