Operating Instructions
KM 85/50 W Comfort / KM 85/50 W Classic / KM 85/50 W P Comfort / KM 85/50 W P Classic
English
29
Setting the sweeping pattern
width for KM 85/50 W Comfort
and KM 85/50 W P Comfort
Note:
The bowden cable must be
readjusted if the sweeping pattern is
insufficient and the bowden cable is
tight when the main brush is in its
lowered position.
!
Set sweeping pattern at the
bowden cable
!
Check the sweep mirror again
Setting the sweeping pattern
width for KM 85/50 W Classic and
KM 85/50 W P Classic
!
Turn the rotary knob(1)
—
Turning it counterclockwise: the
sweeping pattern is increased
—
Turning it clockwise: the
sweeping pattern is reduced
!
Check the sweep mirror again
Replacing the side broom
Replacing it is necessary when the
sweeping effect visibly deteriorates
due to wear of the bristles.
!
Unlock push handle lock by
turning it anticlockwise
!
Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W Comfort and
KM 85/50 W P Comfort it is
additionally necessary to release
the push handle lock!
!
Tilt the machine back
!
Undo screws (3 pieces) at
underside of the side brush
!
Take-off the side broom
!
Slide new side brush onto shaft
!
Fasten with screws (3 pieces)
!
Tilt the machine back upright
Adjusting lowering of side
brush
Readjustment is necessary when
the sweeping efficiency of the side
brush deteriorates due to worn
bristles.
!
Unscrew the locking nut
!
Readjust the setscrew
!
Tighten the locking nut
Adjusting raising of coarse-
dirt flap
Readjustment is necessary when it
is not posible to sufficiently raise or
lower the coarse-dirt flap.
!
Unscrew locking nut
!
Readjust the setscrew
!
Tighten locking nuts
Adjusting and replacing
sealing strips
When the sweeping effect
diminishes due to wear of the
sealing strips they must be
readjusted or replaced
!
Unlock push handle lock by
turning it anticlockwise
!
Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W Comfort and
KM 85/50 W P Comfort it is
additionally necessary to release
the push handle lock!
!
Tilt the machine back
Front sealing strip
!
Loosen the fastening screws of
the sealing strip
