Kärcher KM 130/300 R LPG, Руководство пользователя

Страница: 7 / 19

-
5
1 Operating hour counter
2 Charge warning lamp
3 Oil pressure warning lamp
4 Cooling water temperature warning
lamp
5 Motor suction air
6 Warning lamp fuel reserve
- blinks for reserve
- illuminates when gas bottle is empty
7 Indicator lamp (not connected)
8 Indicator lamp (not connected)
9 Indicator parking light (option)
10 Indicator light low beam (option)
11 Indicator light blinker (option)
12 Indicator lamp - forward driving direc-
tion
13 Indicator lamp - reverse driving direc-
tion
14 Tank indicator (not connected)
In order to perform different tasks, you may
have to fold up the cab (optional) first.
Note : The cab must only be tilted while the
vehicle is on even ground (± 5 °).

Open the cab lock.

Tilt the cab up until the lock lever clicks
into place.

Unlock the lock lever prior to lowering
the cab.

Loosen parking brake; press brake
pedal at the same time.

Activate the parking brake; press brake
pedal at the same time.

Open engine cover.

Turn the freewheel lever of the hydrau-
lic pump by 90 ° down on the side.
Caution
Do not move the machine for long distanc-
es without engaging self-propulsion; a
speed of 10 km/h should not be exceeded.

After moving, fold the freewheel lever
up again.

After moving, fold the freewheel lever
up again.

Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.

Park the sweeper on an even surface.

Remove ignition key.

Lock parking brake.
몇
Warning
Only use replacement cylinders with 11 kg
contents of tested models.

Danger
Risk of injury!
–
Follow safety regulations for LPG vehi-
cles.
–
Formation of crusts and yellow-frothing
deposits on the gas cylinder indicate
leakiness.
–
Cylinders must be changed only by in-
structed persons.
–
Cylinders containing propellant gases
must not be changed in garages and
underground areas.
–
Do not smoke and use uncovered light
while changing the cylinder.
–
While changing cylinders, first close the
locking valve of the LPG cylinder firmly
and immediately put the protective cap
on the empty cylinder.

Loosen the screw on the safety bar and
swivel the bar upwards.
1 Protective cover
2 Gas hose with union joint
3 Gas withdrawal valve
If the warning indicator for reserve fuel
shows an empty gas bottle continuously
during operation, proceed as follows:

Close gas drawing valve by turning it in
clock-wise direction.

Stop the the machine and continue to
run it at idle speed until the motor shuts
off.
Note : This will ensure that all gas lines
are empty and that there can be no ic-
ing which would hinder starting the mo-
tor.

Unscrew the gas hose (30-mm span-
ner).

Screw the protective cap onto the con-
necting valve of the empty gas cylinder.

Open the cliplock.
Multifunction display Before Startup
Fold up the cab
Lock/ release parking brake
Moving sweeper without engaging
self-propulsion
Moving sweeper by engaging
self-propulsion
Start up
General notes
Install/replace gas bottle
Replacing the empty gas bottle
7 EN