Kärcher K 3.95 M, Инструкция по эксплуатации

Страница: 11 / 172

Deutsch
5
The scope of delivery of your appliance is illus-
trated on the packaging. Check the contents of
the appliance for completeness when unpacking.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
These operating instructions describe the maxi-
mum equipment. Depending on the model, there
are differences in the scopes of delivery (see
packaging).
Illustrations on Page 2
1 Coupling element for water connection
2 Connection for water supply with filter
3 Dosage regulator for detergent
4 Suction hose for detergent
5 Transport handle
6 Detergent Tank
7 Storage for trigger gun
8 Storage for accessories
9 Power cable with plug
10 ON/OFF switch for appliance
11 High pressure connection
12 Trigger gun
13 Lock trigger gun
14 High pressure hose
15 Spray lance with pressure regulation (Vario
Power)
16 Spray lance with Dirtblaster
17 Rotary washing brush
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Illustrations on Page 2
Illustration
Î
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Î
Push the high pressure hose into the trigger
gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Î
Check the secure connection by pulling on
the high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Î
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Î
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
This high-pressure cleaner is suited to work with
the KÄRCHER suction hose with backflow valve
(Optional accessory, order no. 4.440-238) to
draw in surface water, e.g. from water butts or
ponds (see specifications for max. suction
height).
Î
Fill the KÄRCHER suction hose with back-
flow valve with water, screw to water supply
and hang into he water butt.
Î
Separate the high pressure hose from the
high pressure connection of the appliance.
Î
Switch the appliance on (I/ON) for a max. of
2 minutes and wait until the water exits the
high-pressure connection without bubbles.
Î
Turn off the appliance "0/OFF".
Operation
Scope of delivery
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Drawing in water from open reservoirs
English 11