Kärcher ICC 1 S D, Руководство по обслуживанию

Страница: 31 / 71

31
ICC 1 S D Basic Settings and Service Procedures
Engine – Engine oil
Checking engine oil level
– After shutting off engine, allow at least five
minutes to pass before checking oil level.
– Oil level must be between "MIN" and "MAX"
marks on oil dip stick (arrow).
– If oil level is found to be below "MIN" mark,
top up with engine oil immediately.
– Do not overfill engine oil to above "MAX"
mark! Refer to Specifications for type of
engine oil required.
Checking oil pressure switch
– Start engine. Oil pressure indicator lamp must
extinguish.
– If indicator lamp fails to extinguish, check /
top up engine oil first.
– Check for switching voltage on terminal of
connecting cable.
– If a voltage is present, oil pressure switch
must be replaced.
– If no voltage is present, connecting cable
must be checked for possible short-circuit
against vehicle ground.
Checking engine oil level
Note:
When the indicator lamp lights up, the engine
will not be shut off.
Changing oil filter / Checking oil pressure switch
Changing oil filter
– Drain engine oil.
– Remove oil filter (2) using cartridge wrench.
– Clean sealing surface at filter base.
– Apply thin film of engine oil to rubber seal of
new filter cartridge.
– Start new filter cartridge on threaded base,
and turn until hand-tight.
1 Oil pressure switch
2 Oil filter