Kärcher HDS 2000 SUPER, Инструкция по эксплуатации, Страница: 25 / 400

– 9

Danger
Scalding danger!
 Set temperature regulator to desired
temperature.

Set the appliance switch the symbol
"Hot Water".
Note: Changing the working pressure and
the feed volume will also change the water
temperature.
 Set dosing value for detergent to "0".
 Set the appliance switch the symbol
"Cold Water".
 Open the hand spray gun and rinse the
appliance for at least 1 minute.
 Close the hand spray gun.
The appliance switches off.
 Open the hand spray gun.
The appliance will switch on again.
If the hand-spray gun is not closed or
opened for more than 30 minutes, the
pump is automatically switched off for safe-
ty reasons.
 Switch the machine switch off and back
on to take the machine into operation.

Danger
Danger of scalding by hot water. After oper-
ation with hot water, the device must be op-
erated with open end handgun with cold
water for at least two minutes.
 Shut off water supply.
 Set the appliance switch to "OFF".
 Pull main plug out of socket with dry
hands only.

Remove water connection.

Activate hand spray gun until device is
pressure less.
 Lock the trigger gun.
Caution
Frost will destroy the not completely water
drained device.

Store in a frost free area.
If the device is connected to a chimney, the
following must be observed:
Caution
Threat of damage by penetrating cold air
through the chimney.
 Disconnect device from chimney when
outside temperature drops below 0 °C.
If it is not possible to store frost free, shut
down device.
For longer work breaks or if a frost free stor-
age is not possible:
 Drain water.
 Flush device with anti-freeze agent.

Empty detergent tank.
 Screw off water supply hose and high
pressure hose.
 Screw off supply hose at boiler bottom
and drain heating spiral empty.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Fill anti-freeze agent of the trade into
swimmer container.
 Switch on appliance (without heater) till
the appliance has been completely
rinsed.
A certain corrosion protection is achieved
with this as well.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
After operation with detergent
Interrupting operation
Turn off the appliance
Frost protection
Shutdown
Dump water
Flush device with anti-freeze agent
Storage
25 EN