Kärcher HDC 60/12 Advanced, Руководство пользователя

Страница: 25 / 376

-
9
You can enter into a maintenance contract
with the concerned Kaercher Sales Office
for the machine.
The machine should be stored in frost-free
rooms. In case there is frosting risk, for e.g.
if the machine is installed in open areas,
then the machine must first be emptied and
flushed using an anti-freezing agent.
 Screw off water supply hose and high
pressure hose.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Fill in normal anti-frost agents in the
swimmer tank right until the top.
 Place the collection trough under the
high pressure exit.
 Switch on the appliance and let it run
until the safety mechanism against lack
of water in swimmer tank gets activated
and the machine is switched off.
A certain corrosion protection is achieved
with this as well.

DANGER
Risk of injury! The main switch is to be
switched off with all repair work.
A Error number
B Number of currently present errors
– Error type 1: Emergency operation of
the system with remaining high pres-
sure pumps.
– Error type 2: The operating readiness of
the system is switched off and the high
pressure pumps are shut off.
– If one of the above errors occurs, the
appliance can be restarted after the er-
ror has been corrected by activating the
release switch.
Note: The 40 most recently occurred errors
are saved with the respective date and time
and can be shown on the display.
A Date of error event
B Time of error event
C Error number
D List location of error
E Number of saved errors
Maintenance contract
Frost protection
Drain water
Flush device with anti-freeze agent
Troubleshooting
Error
number Error description Error
type
01 Control voltage is miss-
ing 2
02 Display, no communi-
cation 2
10 Motor protection switch
high pressure pump 1 1
11 Motor protection switch
high pressure pump 2 1
12 Motor protection switch
high pressure pump 3 1
13 Motor protection switch
high pressure pump 4 1
14 Motor protection switch
of the frequency invert-
er or frequency inverter
not ready 2
18 Winding protection
contact high pressure
pump 1 1
19 Winding protection
contact high pressure
pump 2 1
20 Winding protection
contact high pressure
pump 3 1
21 Winding protection
contact high pressure
pump 4 1
26 Motor protection switch
advance pressure
pump 2
30 Switch "On" constantly
occupied (control in-
put) 2
31 Switch "On" constantly
occupied (display) 2
32 Switch "Off" constantly
occupied (control in-
put) 2
40 Water shortage 2
41 Water temperature is
too high 2
42 Leakage switch-off 1
(e.g. hose burst) 2
43 Leakage switch-off 2
(minor leakage) 2
45 Pressure too high
(> 300 bar) 2
46 Flowmeter issues in-
correct signal 2
47 Overflow valve adjust-
ed incorrectly 2
48 HDC type set incorrect-
ly 2
49 Flowmeter does not
emit signal 2
50 Pressure sensor for
high pressure does not
transmit signal 2
52 Temperature sensor
does not transmit sig-
nal 2
25 EN