Kärcher G 3000 XK, Руководство пользователя

Страница: 13 / 16

English 13
n
Before cleaning any surface an inconspicuous
area should be cleaned to test spray pattern
and distance for maximum cleaning results.
n
If painted surfaces are peeling or chipping,
use extreme caution as pressure washer may
remove the loose paint from the surface.
n
When using on surfaces which might come in
contact with food, flush surfaces with plenty
of drinking water.
n
For additional cleaning tips, visit our website
at karcher.com/us
Recommendations
CLEANING TIPS
Optional accessories are available to further
enhance your cleaning capabilities. These acces-
sories are accurate as of the printing date of this
manual. Please check our website:
karcher.com/us for pricing and up-to-date informa-
tion.
– Extension Hose
– Turbo Nozzle
– 15-Inch Surface Cleaner, 3200 PSI
Optional Accessories
CAUTION
Remove the spark plug cable to prevent accidental
ignition of the engine before making any repair.
TROUBLESHOOTING
Symptom
Cause
Solution
ENGINE WILL NOT
START No gasoline Fill gas tank
Choke is not in the correct
position Slide choke lever out to closed position
Water pressure built up in
the machine Squeeze the trigger to release the pressure
For additional engine problems refer to the engine manual.
NOT ENOUGH
PRESSURE Diameter of garden hose is
too small Replace with a 5/8 inch or larger garden hose
Water supply is restricted Check garden hose for kinks, leaks and
blockage
Not enough inlet water
supply Turn water on full force. Check garden hose
for kinks, leaks or blockage.
Water inlet filter is clogged Remove filter and rinse out in warm water
Black detergent nozzle is
attached Remove black detergent nozzle and attach
high pressure nozzle
OUTPUT PRES-
SURE
VARIES HIGH AND
LOW Not enough inlet water
supply. Turn water on full force. Check garden hose
for kinks, leaks or blockage
Pump is sucking air Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle
Water inlet filter is clogged Remove filter and rinse out in warm water
Spray nozzle is obstructed Blow out or remove debris with a fine needle
Calcified gun, hose or
spray wand Run distilled vinegar through detergent
suction tube.