– 13
Rollers are blocked.
Illustration
Remove rollers and check if an object has become
stuck in the rollers.
Check that the rollers are screwed in as far as they
will go onto the roller holder.
Rollers are too dry.
Moisten the rollers/the device with 50 ml of water in
the park station.
There are parts (e.g. stones or splinters).
Illustration
Remove suction head lid and clean the suction
head.
See Chapter "Cleaning the suction head".
The suction ducts and slits on the suction head are
blocked.
Illustration
Remove suction head lid and clean the suction
head.
See Chapter "Cleaning the suction head".
Waste water tank is overfilled.
Illustration
until
Illustration
Empty the waste water tank right away.
See Chapter "Cleaning the waste water tank".
Waste water tank does not fit properly in the appliance.
Check whether the lid is fit securely on the waste
water tank.
See Chapter "Cleaning the waste water tank".
Separator is blocked.
Remove lid from the waste water tank and clean
the separator.
See Chapter "Cleaning the waste water tank".
The filter net of the waste water tank separator was
damaged during cleaning.
Renew separator.
Cleaning or disinfecting agents are not suitable for the
appliance or were dosed incorrectly.
Only use detergents and care products approved
by the manufacturer.
See chapter "Detergents and care products".
Follow the manufacturer's dosage instructions.
The initial moistening of the rollers was not used or was
not used long enough, meaning that the rollers are not
completely moistened (rollers therefore only clean par-
tially).
Illustration
Completely moisten rollers.
ATTENTION
Do not remove the handle from the basic unit once it has
been assembled.
The handle may only be removed from the basic unit if
the unit is sent out for service purposes.
Illustration
See illustration at the end of the operating instructions
Insert screwdriver at a 90 degree angle in the small
opening at the rear side of the handle and remove
handle.
ATTENTION
Please ensure that the connection cable between the
basic unit and the handle are not damaged.
Subject to technical modifications!
Rollers do not turn
Loud rattling when switched on
Rattling noise in the suction head
Suction power decreases
Appliance is leaking waste water.
Appliance leaves streaks behind on the floor
Removing the handle from the basic unit
Technical specifications
Electrical connection
Nominal battery voltage
25,2 V
Protection class
IPX4
Device
Protective class
III
Charger protection class
II
Rated power of appliance
165 W
Battery type
Li-Ion
Operating time with full charge
approx.
20 min
Charging time for empty battery
4 h
Charger initial voltage:
30 V
Output current, charger
0,6 A
Performance data
Roller revolutions per minute
500 rpm
Filling quantity
Fresh water tank
400 ml
Cleaning station
200 ml
Dimensions
Weight (without accessories and
cleaning fluids)
4,4 kg
Length
320 mm
Width
270 mm
Height
1220 mm
Cable length
Charger
1500 mm
13
EN
