Kärcher CV 66/2, Руководство по обслуживанию

Страница: 9 / 18

English
9
Position of the support strut - appliance hood removed for clarity.
Î
Open the fastening screws of the strut on both sides.
Î
The strut will fall into the inside of the appliance
Î
The appliance hood can now be removed.
Î
When the appliance is assembled, this strut must be installed
pointing straight up.
Î
When the hood is attached, the strut will be pushed into its
original position.
Î
Install the hood from the rear to the front
Î
If you experience difficulties when installing the hood, watch
for edges, use rubber hammer if necessary
Î
While installing, check and ensure that no cables are crushed
Î
Assembly of the appliance in reverse order
The brush roller is connected to the drive motor via a drive belt.
If the drive belt is worn or damaged, it must be replaced.
Î
Remove the screws on the belt cover
Î
Remove cover
Î
Loosen the screws on the support plate of the brush motor -
do not remove all the way
Î
Slide the support plate up to relax the drive belt
Î
Retighten the screws
Î
Remove the drive belt from the front roller and pull it out of the
appliance
Î
Route a new drive belt onto the roller on the motor and stretch
it across the top roller - make sure that all guides are in their
grooves
5.8 Replacing the drive belt of the brush roller