12
Operations
Installation
1.
Location
-Locate the SJ-15 parts washer on a level
concrete surface in a room that is well ventilated.
Protect from damaging environments such as
wind, rain, sun and freezing temperatures.
2.
Electrical
-The SJ-15 is designed for indoor
operation. Refer to the serial plate for proper
voltage and amp requirements for your machine.
All electrical lines must be tested with a voltage
meter for proper voltage before connecting.
NOTE: Correct Rotation of Pump Motor - After
connecting electrical power to parts washer check for
proper rotation of pump motor. Correct rotation is
clockwise looking from the fan end of the motor.
Failure to check rotation and having the motor
operate in a counterclockwise rotation will damage
the pump. Damage will consist of the impeller coming
loose from the motor shaft and damaging the
impeller, shaft seals and pump housing.
CAUTION: All electrical lines must be installed only
by qualified personnel. All installations must be
electrically grounded and conform to all local and
National Electrical codes.
The electrical connection is located on the rear of
the control panel using a 1/2” knock-out. Electrical
conduit must be run all the way to the connection
point in accordance with local codes.
3. Level the SJ-15 by using the leveling pads on the
four corners of the tank.
4. Obtain a detergent designed for parts washer
applications that is suitable for the parts being
cleaned. The detergent must have anti-rust inhibi-
tors added to keep the parts washer from rusting.
5. Fill until low water light goes out.
NOTE: Detergent must be thoroughly mixed
before adding to tank. To ensure detergent mixes
properly and does not foam, make sure machine is
up to operating temperature before adding any
detergent.
Pre-start Checklist
Follow all pre-start procedures
1. Level machine using leveling feet or anchor it to
floor.
2. Verify voltage, then connect the electrical lines to
the machine.
3. Add detergent and water to water tank.
Operating Instructions
1. Voltage light should be illuminated if power supply
is connected. Low water light should be off when
tank water level is correct.
2. Turn the heating element on by setting the 7-day
programmable heater timer. Set the timer by
pulling out trippers on dial to set desired heating
element ON times. Turn dial clockwise until the
time of day is adjacent to time arrow. Heater light
will illuminate when heater element is ON. Allow
about three hours for water to reach operating
temperature. In case of power failure, reset clock
on timer.
3. Set thermostat to the desired temperature.
Suggested operating range is between 130°F to
180°F.
4. Open lid and place the items to be cleaned into the
parts basket. Then close lid. To prevent lifting
injuries, do not attempt lifting basket full of parts.
5. Set the time for the SJ-15 parts washer to operate
by adjusting the wash timer. This is done by
rotating the dial to the desired time set point
(numbers on the face of the timer are in minute
intervals). The wash cycle light will illuminate. This
setting will vary with the degree and type of
cleaning.
Cuda SJ-15 Series Operator’s Manual 9.801-128.0 - V
