Kärcher Cuda 1.043-516.0, Руководство оператора

Страница: 13 / 56

13
Operations
Door Safety Switch
The door safety switch is located on the rear of
the machine, just above the main electrical panel.
The switch is activated with a push-rod that extends
through the wash chamber. The switch disconnects
power to the water pump and turntable motor if the
wash chamber door is opened during a wash cycle.
The water pump and turntable motor will not operate if
the door is not closed and latched correctly.
Adjusting The Door Safety Switch
1. Disconnect power to the machine.
2. Remove the two screws from the rear of the door
safety switch cover and pull the cover free of the
switch assembly.
3. Loosen the adjustment nuts on both sides of the
switch bracket.
4. Adjust the switch accordingly.
5. Tighten the adjustment nuts.
6. Replace the cover.
When properly adjusted, you should hear a slight
“click” as the door latch engages and compresses
the door seal and the door closure safety switch.
Debris Screen
The debris screen is located just below the wash
chamber, and is accessible from the front of the
machine. The debris screen continuously filters debris
particles from the cleaning solution to ensure blockage-
free spray nozzle operation, and also provides a
safeguard against small parts that might accidentally be
washed through from the cleaning chamber.
The frequency at which you must clean the debris
screen depends on machine usage. In general, you
should clean the screen before operating the machine
each day.
NOTE: Never operate the machine without the debris
screen in place, and never remove the screen while
the machine is operating. The screen is specially
sized to filter particles that could clog the spray
nozzles or damage the water pump.
Operating the machine without the debris screen could
cause spray nozzle clogging or water pump failure.
Switch
Protector
Adjustment
Nuts
Adjustment
Bracket
Safety
Switch
Standard Screen: 10 Mesh
Optional Screen: 60 Mesh
Debris
Screen
CUDA 7248 Operator’s Manual 9.801-712.0 - AA