Kärcher BD 45/40 C Ep, Руководство пользователя

Страница: 24 / 348

-
11
In case of danger of frost:
Î Empty the fresh and dirt water reser-
voirs.
Î Store the appliance in a frost-protected
room.

Danger
Risk of injury. Turn the program selection
switch to "OFF" and disconnect the mains
plug before performing any works on the
appliance.
Î Drain and dispose of the dirt water and
the residual fresh water.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Frost protection
Faults
Faults
Fault Remedy
Appliance cannot be
started Check if the mains plug is connected.
Insufficient water
quantity Check fresh water level, refill tank if necessary.
Check hoses for blockages; clean if required.
Insufficient vacuum
performance Clean the seals between dirt water reservoir and cover and check
for tightness, replace if required.
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check if the suction hose and vacuum bar are chocked, clean if re-
quired
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Insufficient cleaning
result Check the brushes for wear, replace if required.
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter
if required.
Drain hose for dirty
water is blocked Open dosing equipment at the drain hose. Pull out the suction
hose from suction beam and close it by hand. Set the program se-
lection switch to suction or vacuuming. The blockage will be
sucked out from the drain hose into the dirt water tank.
24 EN