Risk of Injury or damage to machine!!
NEVER OPERATE THE UNIT IF IT BEGINS TO VIBRATE!
Shutdown the unit and tighten the rotating bar, bolts and fittings.
Connect socket
Click
Click
Quick plug
SHUT-DOWN:
1.
Turn the Pressure Washer off.
2. Turn the water supply off.
3. Squeeze the trigger gun to relieve water pressure.
4. Disconnect and drain the water hose and wipe down unit. Store unit
in a nonfreezing environment.
START-UP:
1
. Lock the trigger gun on the Rotary Surface Cleaner by moving the
safety lock lever to a 90° angle so it rests against the handle grip.
2. Ensure all connections are secure.
3. Unlock the trigger gun and squeeze the trigger while starting the
Pressure Washer.
4. Water will begin flowing from the nozzles of the Surface Cleaner.
Ensure nozzles are not clogged and spray pattern is not erratic.
Turn the pressure washer and water supply off and change nozzles
before proceeding if problems exist.
5. Walk slowly behind the unit, cleaning as you go. If striping occurs,
slow down the pace. Do not allow machine to remain stationary on
soft surfaces such as wood.
6. Check "weep hole" on top of the swivel periodically. Water will seep
slowly. If it shoots out, shut-down the unit and replace seals and/or
main seal.
OPERATION
The Following Contains Operating And Maintenance Instructions.
Do Not Attempt To Operate This Rotary Surface Cleaner Until
You Have
Read And Understood All
Safety Warning And
Instructions Listed In This Manual.
Incorrect Operation Of This Unit Can Cause Serious Injury!
Do Not Alter Or Modify This Equipment In Any Manner!
SAFETY ON
SAFETY OFF
UNDER VIEW
Weep Hole
8
