Kärcher 250 spot, Руководство по эксплуатации

Страница: 10 / 54

ENGLISH Window Washer
6
2. Troubleshooting
Unit does not start
Check battery for correct seating.
Charge battery.
Unit does not spray
Check connections of accessory.
Check to see whether there is still some water in
the fresh-water tank, refill if necessary.
Release air from the unit.
Screw off nozzle from the cleaning head and
clean it carefully under running water.
Unit does not vacuum
Check connections of accessory.
Check seating of the dirty-water tank.
Check seating of the rubber blade.
Other malfunctions
The authorised customer service must be
instructed to deal with other malfunctions.
3. Technical data
Operating voltage (battery) 8 V
Operating pressure (spray pump) 1 bar
Fresh-water tank 250 ml
Dirty-water tank 250 ml
Operating period of the unit
with fully charged battery
approx. 35 min
Charging time for empty battery approx. 15 hours
Voltage of the battery charger 9 V
Charging current 500 mA
Weight (when ready to operate) 2.7 kg
Dimensions:
Length x width x height 250 x 130 x 260 mm
Sound level (under battery operation) 69 dB(A)
Cleaning and storing the unit
• Press the release buttons at the side and
detach the dirty-water tank from below. (Fig. S)
• Empty the dirty-water tank. When replacing it
in the unit, make sure that the release buttons
snap into place. (Fig. T)
The dirty-water tank should always be
emptied before the fresh-water tank is refilled,
otherwise water can overflow and damage the
unit.
• Always recharge the battery overnight before
storing the unit. (Fig. C)
• The grip section of the cleaning head can be
fastened to the carrying handle on the unit for
storage or transport purposes. (Fig. U)
Indicator lamp on the unit
• The indicator lamp can illuminate briefly when
the vacuum action is switched on.
• If the indicator lamp is continuously illuminated
while the unit is in use, the battery must be
recharged immediately. (Fig. V)
Replacing the rubber blade and felt strip
• Replace the rubber blade if there are still stripes
on the surface being cleaned after it has been
vacuumed.
• To replace the rubber blade or felt strip, open
the slider on the cleaning head and remove the
cover of the cleaning head. (Fig. W)
• When replacing the rubber blade, take into
account that it can be inserted from both sides
and used twice. (Fig. X)
• Replace the cover and lock into place by
closing the slider