Kärcher 1500 Series, Руководство по эксплуатации

Страница: 12 / 30

12
Operations
Handle Installation
The handle must be installed by qualified personnel. Read all instructions thoroughly. The machine is
shipped with handle unassembled.
La poignée doit être installée par du personnel qualifié. Lisez toutes les instructions attentivement. La
machine est livrée avec la poignée démontée.
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle and chassis assembly from carton.
2. Attach handle assembly to base using hardware kit (preinstalled in base) items 1 and 2.
NOTE: The bushings (items 1) are required for the correct operation of the handle. The bushings are
positioned inside the pivot holes in the chassis, and are held in place by tightening the screws (item 2) against
the bushing.
3. Remove bolt, nut and washers (items 3, 4 and 5) from lower block on handle assembly. Attach links as
shown. Tighten bolt and nut securely, then back off 1/4 to 1/2 turn. Fully tighten bolt and nut on rear of lower
block on handle assembly.
4. Check handle for movement up and down.
Plug motor cord into handle cord receptacle by routing the cords above the handle links.
HANDLE
ASSEMBLY
CHASSIS
ASSEMBLY
HOLE
PIVOT
HANDLE
RECEPTACLE
4
5
3
MOTOR
PLUG
1
2
86387270 Operator’s Manual - Floor Burnisher (1500 Series)