Operating Manual HDS Standard 9.808-214.0
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
12
Operating With Cold Water
Removal of light contaminations and clear rinse, i.e.:
Gardening tools, terrace, tools, etc.
• Set operating pressure according to need.
ECO Operation
The appliance works in the most economical temperature
range.
Note:
The temperature can be regulated up to 140 °F/
60°C.
Operating With Hot Water
DANGER: Scalding danger!
Set temperature regulator to desired temperature.
We recommend the following cleaning temperatures:
Light contaminations
86 °F/30 °C-122 °F/50 °C
Contaminations containing protein, i.e. in the food
processing industry
max. 140 °F/60 °C
Vehicle cleaning, machine cleaning
140 °F/60 °C-194 °F/90 °C
Turn Off The Appliance
DANGER: Danger of scalding from hot water! After
the operation with hot water the device must be
operated with opened gun with cold water for at least
two minutes.
If detergents were used, draw clear water through the
detergent line to purge detergent.
• Shut off water supply.
• Open the hand spray gun.
• Switch on the pump with the power switch and allow
to run for about 5-10 seconds.
• Close the hand spray gun.
• Set the appliance switch to "0/OFF".
• Pull main plug out of socket with dry hands only.
• Remove water connection.
• Activate hand spray gun until device is pressure less.
• Secure the trigger gun. To do so, push the safety catch
towards the front.
ASSEMBLY & INSTALLATION INSTRUCTIONS
Suggestion to lift the appliance with a crane using a sling.
CAUTION: Risk of damage! Not recommended to load
the appliance with a forklift.
CAUTION: Risk of personal injury or damage! Mind the
weight of the appliance during transport.
When transporting in vehicles, secure the appliance
according to the guidelines from slipping and tipping over.
ATTENTION: Protect trigger gun, lance and hose reel
from damage during transport. It’s not suggested to
transport with accessories mounted on the appliance.
TRANSPORT
STORAGE
Protect from freezing by storing in a heated area, or by
flushing the system with antifreeze (use an automotive
engine antifreeze or windshield washer solvent to
antifreeze). To flush the system with antifreeze, attach
a short length of hose to the garden hose connector
located on machine water inlet. Place the other end of
the hose into a container of antifreeze. Start machine
and allow to run until antifreeze flows from the end of the
wand. Squeeze and release the trigger of the trigger gun
several times to antifreeze the unloader system. Also draw
antifreeze through the detergent inlet line to antifreeze the
detergent system. For added protection after anti-freezing,
disconnect the pressure hose from machine. After coil
has drained, reconnect pressure hose. If the pressure
washer is not to be used for an extended length of time, it
is recommended that the system be flushed with antifreeze
for rust protection.
• Lock in the lance into the holder of the appliance
hood.
• Roll up high pressure hose and electrical conduit and
hang them into the respective holders.
Note:
Do not twist high pressure hose and electrical
power cord.
