16
•
If your Bluetooth enabled device does not support A2DP, it will not play the music
through the KN355BTB system even after it is paired and connected successfully.
•
If you are pairing and connecting your personal computer to the KN355BTB using
Bluetooth, you may need to set the KN355BTB as your computer’s default sound device.
RE-LINKING TO A SMARTPHONE OR BLUETOOTH ENABLED DEVICE
Even if your smartphone or Bluetooth device is already paired with the KN355BTB and with
both Bluetooth functions turned on, they can become unlinked at some point due to
intentional manual disconnection or undesirable external signal interferences or over-range
for more than 10 seconds. If this happens, the Turntable unit will emit a low level alert beep
tone. You can re-link them and resume play by:
1. Select “KN355BT” from the device list on your smartphone or Bluetooth device. The
KN355BTB should re-link to your Bluetooth enabled device within 5 seconds.
2. Tap the play button of the music player on your Bluetooth enabled device to resume
playback.
ANSWER THE INCOMING CALL
When your unit is playing music by Bluetooth and you receive an incoming call on your
mobile phone, the music will stop and the ring tone will sound from your mobile phone.
When you end the call, the music will play again automatically.
LED LIGHT SHOW
- To turn off the LED light show, press the LIGHT SHOW button.
- To turn on the LED light show, press LIGHT SHOW button again.
Note:
If the brightness is glaring, turn on room lights or turn off LED light show.
RESETTING THE UNIT
If the system does not respond or exhibits erratic or intermittent operation, you may have
experienced an electrostatic discharge (ESD) or a power surge that triggered the internal
microcontroller to shut down automatically. If this occurs, simply disconnect the AC Adapter.
Wait for at least 3 minutes and then setup the unit again as if you were using it for the very
first time.
CARE AND MAINTENANCE
1. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be
used.
2. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
3. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
4. If drop-outs or interruptions occur in the music during CD play, or if
the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.
