Kapriol KME 1600, Руководство пользователя

Страница: 15 / 36

15
ORIGINAL ACCESSORIES / ATTACHMENTS.
Use only the accessories and attachments detailed in the operating instructions.
The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an
injury.
BEFORE FIRST USE - WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying
out any work in the device.
PLACING A WHISK
NOTE:
Use only whisks conform the specified diameter.
• Screw the whisk with thread (M14) as far as possible in the tool
• Tighten the whisk properly with an open-end wrench.
FIRST USE : The mains voltage at the mains socket must match that shown on the rating plate on the device.
USING: Improper use may damage the instrument.
OBSERVE THEREFORE THESE INSTRUCTIONS:
• Use a tool up to the specified diameter.
• Load the tool in such a way that the speed would not drop considerably or that it would stop.
• Check if the data on the rating plate correspond with the actual mains voltage.
ON / OFF
• Press button 1 and then press button 2; at this point the machine turns on
• If button 1 is not pressed, button 2 does not function
• Release button 2 to stop the machine
IMPORTANT: IF YOU ACT FORCE ON BUTTON 2 WITHOUT PRESSING BUTTON 1 FIRST, THE SWITCH
WILL BREAK
INFINITELY ADJUSTABLE SPEED SETTING
Two rpm ranges can be pre-selected with the speed selector switch:
Gear 1 180-380 /min
Gear 2 300-650 /min
The necessary speed depends on the type of the material mixed and it is recommended to verify it by a practical test.
MAINTENANCE CLEANING AND STORAGE
WARNING! DANGER OF INJURY!
Switch the device off and pull the plug out of the mains socket before carrying out any work on the device.
Correct maintenance for the machine can prolong the working life; The handle switch must always keep in proper function and good
maintenance;
The mixing tools should be cleaned when the poeration is finish or no use for long time; Use a cloth to clean the device.
Normally the flowing water can clean the mixing tools well. Do not under any circumstances use petrol or strong solvents. Do not allow
any liquids to enter the device.
The vent of motor housing can not be covered when the machine is in operation, there can not be any flammable materials in the
machine;The vent must be often cleaned;
Store the device & accessories in a dry room where out of the reach of children also.
Only original parts can used in this machine.