COMMANDS
51
USers
n
(n = 0 – 26)
default 1
KPC-1
/
KPC-2
/
KPC-2400
Packet
default 1/1
KAM
/
KPC-4
Packet
This command specifies the channels (streams) which may be available to incoming connect re-
quests. For example, if USERS = 5 then an incoming connect request will connect to the lowest
channel A – E, if any of these channels are in the unconnected state. If none of the 5 channels are
available (all of them are connected), a <DM> packet will be sent back to the requesting station
and the message
***connect request: (call)
will be output to your terminal, if permitted.
If USERS are set to 0 no one will be able to connect to you. If USERS is set higher than
MAXUSERS, the extra is ignored and the message
USERS LIMITED BY MAXUSERS
will displayed.
See also: intface, maxusers, streamsw
USOs
ON | OFF
default ON
KAM
RTTY
When ON, an unshift to letters case is effected when a space is received in BAUDOT RTTY. If
LCRTTY is ON, a space will cause an unshift to lower case.
V
ersion
V 5.0
immediate
KAM
Shows the software version.
Wefax
n
immediate
All Units
WEFAX
This command permits the reception of Weather Facsimile. The audio input is sampled n times per
second, and a black/white decision is made on each sample. Each sample becomes one bit of the
data sent over the serial port to the computer. A special computer program must be used to dis-
play the WEFAX picture.
See also: daytweak; WEFAX Reception section of Operating Manual
WText
message {up to 128 characters)
default (blank)
KAM
AMTOR
This entry specifies the text to be sent in response to a WRU command while in AMTOR (ARQ)
Mode only. Enter any combination of characters and spaces up to a maximum length of 128. Enter-
ing single
%
will clear WTEXT.
See also: Ctrl-W in the Directives section
