Kanto Tuk, Руководство пользователя, Страница: 7 / 16

7
OUT
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two
conditions:
(1) This device may not cause
harmful interference, and (2) this
device must accept any
interference received, including
interference that may cause
undesired operation.
FCC ID: QKH-KANTOTUK
IC: 10678A-KANTOTUK
ON
OFF
POWER
5V / 2A
100-240V ~ 50/60 Hz
Max Power Consumption 120W
FUSE:T3.15AL 250V
www.kantoaudio.com
Designed in Canada
Made in China
SUB
OUT
OPT
RCA
USB
PHONO
GND
L R L R
Serial Number
IN
Setting up TUK
Ensure that the Power Switch is in the OFF position.
Connect the two speakers together as shown below using the supplied speaker cable.
Connect the RED (+) and BLACK (−) terminals from the active speaker to the corresponding
terminals on the passive speaker. If you wish to place your speakers farther apart than the
supplied cable will reach, we recommend that you purchase a heavier gauge of speaker cable
to minimize signal loss.
Follow the instructions on the ensuing pages to connect your audio sources to TUK. The
examples in the following pages are not meant to be exhaustive - just examples.
Connect the AC power cord from TUK’s active speaker to your wall outlet. Turn the Power
Switch to ON once all the inputs have been plugged in.
TUK is designed to perform optimally when positioned at least 8” from the rear wall in an
average listening room. However, it may not be possible to install the speaker in this position
and since rooms vary in shape, size, and furnishing, a certain amount of experimentation
is necessary to determine the most suitable position. Moving the speaker very close to the
rear wall will enhance the bass frequencies but will tend to reduce soundstage depth, while
moving the speaker away from the rear wall will tend to have the opposite effect. Avoid
positioning the speaker close to or in the corner of a room, as this will excite undesirable
room coupling in the low and middle frequencies. Room characteristics and positioning
have a profound effect on the performance of the speakers, so time and effort devoted to
achieving the optimum positions will be rewarded.
ATTENTION
When connecting audio cables the Power Switch must be turned OFF. After connecting all
cables, the unit can be turned ON. When the volume is high, this system can produce noise
levels that could permanently damage your hearing. TUK is a self-powered speaker system.
Do not connect the speaker inputs to the outputs of a stereo amplifier. Damage may occur.
Use only the power cord provided with TUK.