v
Compliance Specifications
Europe
This product is in conformity with:
•
EMC Directive 2004/108/EC based on results using harmonized standards in accordance with article 10(5), and
•
LVD Directive 2006/95/EC based on results using harmonized standards.
The product is labeled with the CE mark as proof of compliance with the above mentioned European Directives. Also a CE declaration of
conformity (DoC) for this product can be found at www.kantech.com under Agency Listings section.
FCC Compliance Statement
CAUTION: Changes or modifications not expressly approved by Kantech could void your authority to use this equipment. This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Re-orient the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: ‘How to Identify and Resolve Radio/Television Interference Problems’.
This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.
Industry Canada Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Important Safety Instructions
WARNING: Read and save these instructions! Follow all warnings and instructions specified within
this document and/or on the equipment. These instructions shall be used in conjunction with the
User’s manual of the power supply.
CAUTION: There is no ON/OFF SWITCH for the power supply. The AC power supply coupler serves
as a means of disconnection from the supply mains.
•
This Intevo equipment shall be used and installed within an environment that provides the pollution degree max. 2 and overvoltages
category II NON HAZARDOUS LOCATIONS, indoor only. The equipment is FIXED or DESKTOP and CORD CONNECTED and is designed to be
installed by service persons only; [a service person is defined as a person having the appropriate technical training and experience
necessary to be aware of hazards to which that person may be exposed in performing a task and of measures to minimize the risks to that
person or other persons.].
•
Ensure that cables are positioned so that accidents can not occur. Connected cables must not be subject to excessive mechanical strain.
To reduce the risk of fire, electric shock and/or injury, observe the following:
•
Do not spill any type of liquid on the equipment.
•
Do not attempt to service this product yourself. Opening or removing the cover of the power supply may expose you to dangerous
voltage or other risk. Refer servicing to qualified service personnel. Never open the device yourself.
•
Do not touch the equipment and its connected cables during an electrical storm; there may be a risk of electric shock.
•
Do not locate this product where persons can walk on the cables.
•
Do not connect this server to electrical outlets controlled by switches or automatic timers.
NOTE:
Opening the Intevo casing will void the warranty.
Cleaning
•
If the surface of the equipment is contaminated, breathe on the surface and gently wipe it with a soft, dry cloth.
•
Do not use abrasives, water, thinners, solvents or aerosol cleaners (spray polish), any aromatic solvents, etc. that may enter through holes in
the equipment and cause damage.
