KANSAI SPECIAL SX Series, Инструкция

Страница: 6 / 21

3
3333----2 2 2 2 Motor & belt Motor & belt Motor & belt Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt
: M type V belt
Select the proper motor pulley according to the machine speed (refer to the motor pulley
outer diameter in the table below.) Position the motor by pressing the finger onto the
mid-point of the belt so that 1 ~ 2cm deflection can be achieved (see the illustration).
Machine speed
Motor pulley outer
diameter
50Hz 60Hz
75
㎜
3500SPM
85
㎜
4000SPM
90
㎜
3500SPM
95
㎜
4500SPM
100
㎜
4000SPM
110
㎜
4500SPM
【
4
】
LUBRICATION
4444----1 1 1 1 Oil Oil Oil Oil
Use Kansai Special's genuine oil. (Part No.28 - 617)
4444----2 2 2 2 To fill the machine with oil To fill the machine with oil To fill the machine with oil To fill the machine with oil
Remove screw A and B from the oil hole.
Fill the machine with oil until the oil level reaches the top
line on oil gauge E and D. Maintain the oil level between
the lines of the gauges.
4444----3333 To check for proper oil flow
To check for proper oil flow To check for proper oil flow
To check for proper oil flow
After filling the machine with oil, run the machine to
check the oil is splashing to oil flow sight window C and F.
When starting a new machine after filling the reservoirs,
or when beginning to operate a machine that has been
idle for some time, it may be necessary to prime the pump.
To do this, remove the two plug screw G.
Apply oil from an oil can to these holes and operate
machine until bubbling can be observed at the windows.