219 Route 206 Phone: 1-800-247-8887
PO Box 372
Fax: (973) 786-7586
Andover, NJ 07821 USA [email protected]
6813
™
User Manual, PN 10283
Kanomax USA, Inc
Rev 2.0, 24-Nov-2009
www.kanomax-usa.com
Copyright © 2008, Kanomax USA, Inc.
Page 16 of 24
TM
APPENDIX F – RS232 COMMUNICATIONS (IF EQUIPPED)
If the instrument is equipped with the RS232 Communications option,
there will be a three pin male connector on the bottom of the instrument.
Also, an RS232 cable will be included with the instrument. This cable
will have a three pin female connector on one end and a DB9 Female
connector on the other end.
RS232 Data Output – Instructions for Use
STEP 1: Connect the RS232 cable (included) to the female connector
on the bottom of your instrument. Connect the other end to an
RS232 port on your computer.
STEP 3: Turn the Instrument ON.
STEP 4: Verify that the Instrument has been set up as a RS232 Serial
Port with a unique COM port number. (You only need to do
this once). For Windows users, open the Windows Device
Manager (found in Control Panel) and verify that a serial port
exists.
You are now ready to capture the data being measured by
your instrument.
Please refer to
Appendix G – Viewing and Capturing Data
for further instructions.
219 Route 206 Phone: 1-800-247-8887
PO Box 372
Fax: (973) 786-7586
Andover, NJ 07821 USA [email protected]
6813
™
User Manual, PN 10283
Kanomax USA, Inc
Rev 2.0, 24-Nov-2009
www.kanomax-usa.com
Copyright © 2008, Kanomax USA, Inc.
Page 9 of 24
TM
Press the MAX/MIN key to record and display the maximum reading
for either temperature or air velocity. The maximum reading display
will alternate with the letter “H” displayed with the sample rate. Press
the MAX/MIN key again to record and hold the minimum reading.
The minimum reading display will alternate with the letter “L” displayed with
the sample rate.
For example:
1065
alternating with
H 8
signifies that 1065 is the highest airspeed
reading since the MAX/MIN key was pressed, and the sample rate is set to 8
seconds.
82
alternating with
L 16
signifies that 82 is the lowest airspeed
reading since the
MAX/MIN key was pressed, and the sample rate is set to 16
seconds.
To exit MAX/MIN mode, press the SAMPLE RATE key.
Press the HOLD/RESET key to freeze the current reading on the
display.
HOLD
is displayed on the LCD and the reading is held.
Press the HOLD/RESET key a second time to clear this mode and return the unit
to normal operation.
Press the HOLD/RESET key while in MIN/MAX mode to display BOTH the
minimum and maximum readings since the MAX/MIN key was pressed. Once
the HOLD/RESET key is pressed while in MAX/MIN mode, new readings are
no longer recorded. To return to MAX/MIN mode, press the HOLD/RESET
key again.
