T
echnical manual OT-600-060/1
Page 13
SEPARATING COMPRESSOR- AND FAN/HEATER ASSEMBLY
Tools required:
•
Torx keys T10 and T20
•
Cutting pliers
•
7 mm spanner
a) Cut loose the cable ties for the hand controller cable, for the electric overpressure valve, the
compressor cables and the 4 mm silicone tube. Cut lose the tie that secures the 15 mm silicone hose.
b) Disconnect the compressor by separating the two cable connectors.
c) Remove the seven earth cables from the common earth point (7 mm nut).
d) Remove the mains inlet (two T10), disconnect the mains cables from the inlet.
e) Carefully remove the cable connector on the alarm board.
f) Remove one end of the 15 mm silicone air tube.
g) Remove the eight T20 screws that hold the air silencers from the front plate (mind the rubber lined
washers).
h) Remove the three T20 screws from the bottom / back, and the two T20 screws from the outer / top
of the assembly.
i) Gently separate the compressor assembly from the fan/heater assembly. Mind the cables!
Assemble in reversed order. Re-fit the cable ties. Make sure the gaskets are correct positioned and that
the rubber lined washers are fitted on the eight frontal T20 screws.
PICTURES
Pulling the chassis out of the casing. The
mechanical over pressure valve is visible in the
bottom of the front side.
Chassis, left side with the main PCB and the
compressor.
Chassis, right side. The electrical over pressure
valve visible in the bottom of the assembly.
Removing the compressor air filter
