Kanguru
Slim FC-RW
- 15 -
4.
Operation—Copying Flash Cards
Basic Operation Mode
1. Connect the power cable to the back of the device (if battery is dead).
2. Press and hold the power button for 2 seconds to turn on the device.
3. Insert a flash card into the appropriate card reader slot.
4. Insert a CD-R or CD-RW disc into the CD tray.
5. Press the
STOP/ESC
button to bring up the menu in the LCD panel.
6. Press the
PREV
or
NEXT
button until
COPY
appears in the LCD panel.
7. Press the
ENTER/PLAY
button to begin the copy process.
8. The unit will display the % left of the burning process.
9. Once the copying is finished the FCRW will
CLOSE
the CD and then
display
END
to complete the process.
Note1: Keep the Kanguru Slim FCRW on a flat surface during operation.
Do not tilt or pickup the device as it may cause damage to the unit.
Note2: Do not leave CDs in the device while transporting.
Disk Spanning
The Kanguru Slim FCRW supports discs spanning which allows you to copy from
flash cards that are larger than the space available on the CD-R/RW disc. When
the CD becomes full the Slim FCRW will prompt you to insert a new blank disc.
After inserting a new disc the burning will automatically continue. This can be
done up to four times in one burning session.
Erasing a CD/RW
There are two methods which you can use to erase a CD-RW.
To erase a CD-RW when the Slim FCRW is connected to a TV/Projector, please
follow the steps below.
1. Insert the CD-RW disc to be erased.
2. Select the
ERASE
CD-RW menu item and select
YES
3.
ERASE COMPLETED
will appear on the LCD screen when the disc is
fully erased.
When the Slim FCRW is in stand –alone mode, please follow the steps below.
1. Insert the CD-RW disc to be erased.
2. Press the
STOP/ESC
button to bring up the menu in the LCD panel.
