K&S KS 400WS, Руководство пользователя, Страница: 8 / 14

CHECKING THE FUEL LEVEL
CHECKING THE FUEL LEVEL
1. Unscrew the fuel cap and check the fuel level in the tank.
2. Fill the fuel tank to the fuel filter level.
3. Tighten the fuel cap securely.
Recommended fuel:
Recommended fuel: only unleaded gasoline.
Fuel tank volume: Fuel tank volume: see specifications table.
Wipe up spilled fuel immediately with a clean, dry, soft
cloth, as the fuel may harm painted surfaces or plastic parts.
IMPORTANT!
CHECKING THE OIL LEVEL
CHECKING THE OIL LEVEL
The wood chipper shredder is transported free of motor oil. Do not start the engine until it is filled with
sufficient amount of motor oil.
1. Unscrew the oil dipstick and wipe it out with a clean cloth.
Use only unleaded gasoline. Using leaded gasoline can
cause serious damage to the inside of the engine. It is
forbidden to use kerosene or other fuel types.
IMPORTANT!
The engine is supplied without oil and fuel.
IMPORTANT!
OPERATING INSTRUCTIONS AND WARNINGS
7
CHECK BEFORE GETTING STARTED
8
If there are many uncut materials, blades may be needed to sharpen or intervals are needed to make
adjustment. It is easy to cause injury due to blades are sharp enough. Sharpen or adjust blades should go
to indicate maintenance point. The recommendation of blade intervals is 1-2min.
FOR MODELS KS 500WS, KS 700WS FOR MODELS KS 500WS, KS 700WS choice of chipping material: the fresh cut trees branches in max.
aggregate diameter of feed material indicated in the table with technical data on page 3 (the total diameter
of the branches should not exceed 15-40 mm) , and straws can be chipped directly. Due to different hard -
ness and moisture content, the engine may stop midway or the machine body may shake during the work-
ing, thats normal. Our recommend max. chipping capacity point to the annual plant, such as trees, bamboo
and straws. If chipping the perennial plant, you should shorten the chipping diameter and lessen the
material to feeding hopper . The ideal chipping for this machine is suitable for fresh cut with 80% moisture
content plant. During the chipping process, you should obey the rule: Big side first, small side later, the
trunk first, the branch later. In order to get good chipping, it’s better put branches and leaves together with
the the bulk or segment of big trees. Block and short materials are not allowed to be chipped separately, for
the safety of the operator and the good of the blades, they are better to be crushed with branches or straw.
CHIPPER OPERATION KS 400WS
CHIPPER OPERATION KS 400WS
The chipper is designed to handle tree limbs and branches up to approximately
3” (7,6 cm) in max. aggregate diameter of feed material. The total diameter of
the branches should not exceed 15 mm. The chipping knives also permit the
processing of course organic matter like corn stalks. Tree branches must be
inserted large-end first into the chipper cone. Since occasional kick-backs may
occur, always stand off to the side of the unit. Allow the self-feeding action of the
unit to draw the sticks in.
SHREDDER OPERATION
SHREDDER OPERATION KS 400WS KS 400WS
The shredder is designed to shred leaves, and other soft but bulky organic waste
and branches up to 15 mm in diameter. As material is loaded into the shredder
hopper it is pulled into the path of the triangular and J-hammers by air flow.
www.ks-power.de/en
| 7