K&S KS 400WS, Руководство пользователя, Страница: 10 / 14

STORAGE
STORAGE
The machine must be stored in a dry, well-ventilated and dust-free indoor area.
Don’t overload the shredder by dumping large volumes of
material into the hopper opening.
IMPORTANT!
Do not store a fueled unit in an enclosed structure.
NOTICE
TROUBLESHOOTING
10
Never put your hands into the shredder hopper. Never
put very hard or dry materials such as kiln-dried bulky
lumber (2x4) or other building materials into the shredder
hopper. Never load wood products that have been
preservative-treated under pressure into the shredder.
ATTENTION!
THE COMMON FAULTS ELIMINATION METHOD
The engine cannot be started
Check the fuel ON-OFF, see if it’s ON, check if gets enough fuel and
lubrication oil, check the emergency stop button.
Engine flameout midway
Check if the engine is stopped by overloading, check if something
blocked in the chipping hopper, check the emergency stop button and
protection switch.
The hopper blocked
Stop the machine, and remove the hoppers and the cap of bearing,
turn the shaft of roller by the right spanner in the toolkit to clear the
blocked material. Don’t touch the blade during the working, make
sure your hands not to be cut by the blades.
Has strange noise
Stop the machine, check if the fastener gets loose, if not, let the
professionals to check the repair.
The blade destroyed
Go to the professional repair point to change or repair the blades.
The belt damage
Open the belt cover and change the belt.
The material grinding not sufficient
Let the professional to adjust the blade space, the recommended
space for rough chipping is 1for fine chipping is 0.1 mm- 1.2 mm
REGULAR MAINTENANCE CHECKLIST
11
This manual compliance! You can find a list of service center addresses on the website of exclusive importer:
www.ks-power.de/en
TRANSPORTING TRANSPORTING
• ALWAYS use the built-in wheels to move the chipper shredder. Handling must only be carried out with
the engine off!
• DO NOT store the chipper/shredder near an ignition source
• Store the chipper/shredder in a well ventilated area.
• If the engine is not to be used or is to be stored for more than one month the following storage procedure
should be carried out. Drain all the fuel from the fuel tank and the carburetor ensure that all the fuel has
been removed. Remove the spark plug and pour approximately one tablespoon full of clean engine oil into
the spark plug hole. With the ignition turned OFF gently pull on the recoil starter cord several times. Re-fit
the spark plug continue to pull the recoil starter cord until the piston is on the compression stroke (when
resistance is felt) then stop pulling.
www.ks-power.de/en
| 9