16
heat, indicated by an “H”)
Note: The data in the table is for guidance only. The relation between the heat setting and the
cooking zone consumption of power is not linear. When you increase the heat setting it is not
proportional to the increase of the cooking zone consumption of power.
The power of the cooking zones can be different in some small range. It changes with the material and
dimensions of the cookware.
TECHNICAL INFORMATION
Voltage: 220-240 V 50/60 Hz
Model: SL-1800S Max. power: 2000W
CLEANING
Do not use steam cleaners.
Before cleaning, make sure the cooking zones are switched off and that the residual heat
indicator (“H”) is not displayed.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
Sugar or foods with a high sugar content damage the hob and must be immediately removed.
Salt, sugar and sand could scratch the glass surface.
Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s
instructions).
TROUBLESHOOTING GUIDE
Read and follow the instructions given in the section “Instructions for use”.
Check that the electricity supply has not been shut off.
Dry the hob thoroughly after cleaning it.
If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table
for instructions.
If the hob cannot be switched off after using it, disconnect it from the power supply.
Error
code
Possible Cause
Remedy
E0
No Pan or did not detect the pan
Put on the pan
E2
NTC short or open
Contact the after-sales service and specify the
error code
E3
High voltage
Contact the after-sales service and specify the
error code
E4
Low voltage
Contact the after-sales service and specify the
error code
E5-E8
A lot of possibilities, the cooktop must
be sent in for repair
Contact the after-sales service and specify the
error code
E7
Hob too hot because of bad airflow or
the fan is broken
Contact the after-sales service and specify the
error code
