Kamstrup RF Router, Руководство по установке

Страница: 8 / 12

5512-104 DK
GB DE
S
E/01.2005/R
e
v.
B1
8
Data from RF Router.
Data to RF Router.
Amount of energy meters within radio
range. One energy meter, one flash.
Amount of RF Routers.
One RF Router, one flash.
Amount of RF Concentrators.
One RF Concentrator, one flash.
■
■
■
■
■
Installation
Using external antenna No. 66 99 407,
mount the MCX plug on the connection
board inside RF Router, no tools needed.
Using external antenna No. 66 99 408,
strip the antenna cable, bend the shield
backwards onto the isolated part of the
wire. The shield should now be mounted
in the wire-arrester to secure a good and
proper ground plane for the antenna wire.
Strip the inner core and place it in the
screw terminal.
Network installation
To be able to use below as status indica-
tion on the radio network, you must install
of one or more Kamstrup energy meters
and network units in the area.
RF Router – installation test
Mount the RF Router top after installation,
and keep pressing the front key until the
LED turns on in the right side marked
“Meters”.
Release the front key and the RF Router
starts creating its local list via radio
communication. The LED’s no. 1 and 2
flash on and off for max. 2 minutes.
When the LED’s go out the local list has
been created and can be read either
directly on the RF Router, see “RF Router -
Local list test” or via a hand-held terminal
with radio flash 6699 160.
RF Router – Sign up for the radio network
Keep pressing the front key until the
LED’s turn on in the right side marked
“Meters” and “Routers”. The RF Router
sends a sign up inquiery to the nearest
RF Concentrator. The LED’s no. 1 and 2
flash on and off.
If all 3 LED’s then turn on, the RF Router is
signed up for the radio network.
RF Router – Local list test
Keep pressing the front key until the LED’s
turn on in the right side marked “Meters”,
“Routers” and “Concentrators”. The local
list is displayed when the LED’s flash on
and off, see next picture.
Check the antenna
switch inside
RF Router.
If mounted with
external antenna,
place the switch
knob at EXT.