3
Item
Qty
Awning flysheet
1
Spreader pole
2
Groundsheet 1
4 berth inner tent
1
If you are missing any parts please contact your supplying dealer.
Before using for the first time please check the contents of your awning
ATTACHMENT TO VEHICLE
The Travel Pod has a tunnel at the rear that can be attached to a vehicle—like
the side door of a camper van (VW style).
Keder Beading
The tunnel also has Keder beading sewn to its top edge. The beading can be
threaded into ‘figure of 8’ extrusion (not supplied) and the figure of 8 clipped to
the gutter on the side of the camper. Kampa Figure of 8 extrusion is available
from your supplying dealer.
Guy Line/Rope
If you camper does not have a gutter it is possible to pull the tunnel to the
vehicle by attaching guy lines/ropes (not supplied) to the top corners of the
tunnel, throwing these over the vehicle and tying them to the wheels or pegging
them down. Take care that the guy lines/ropes do not damage the vehicle.
Velcro Straps
If your vehicle has roof bars installed, the velcro straps, attached to the pole
sleeve, can be fixed around them.
Pole & Clamp Fixing (optional parts required)
This requires an optional pole and clamp set available from your dealer. The
pole is threaded through the sleeve in the top of the tunnel. This is then
dropped into the gutter on the side of the camper and secured using the clamps
provided.
Using your roll out awning (if fitted)
The Keder beading can be slid into the channel found on the front of most roll
out awnings. It may be necessary to use a Drive-Away kit to convert the size of
the beading. Your dealer will be able to offer more advice.
Hand pump
1
Peg bag
1
Carry bag
1
Item
Qty
