Kamikaze ORIGINALE VOLPI PV295, Руководство пользователя

Страница: 39 / 148

39
14.2. Opening change (only in progressive mode)
The KV360 shears incorporates a system of change of opening with memory.
It means that we can adjust the opening of the head in function of the diameter of cut
wished.
In the progressive cutting control mode, the cutting diameter can be adjusted and a smaller
cutting diameter can be set, for which the position of the blade at the desired cutting
diameter must be maintained for 1 second and an audible warning will sound (a beep)
indicating that the selected cut-off opening diameter has been memorized.
Press the trigger twice in rapid sequence to activate the pruner and a confirmation tone will sound.
To return to full open, keep the trigger pressed until you hear two beeps, one single then three in
sequence, indicating that the opening memory has been removed.
Caution: please check battery charge level or blade sharpening when cutting is difficult or not
smooth.
15. Maintenance and cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining and repairing the pruning
shear, to avoid risk of unexpected activation of the tool.
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
Please wear glove before you check the blade is sharp or not, that is to avoid blade hurt you.
Check the pruning shear frequently, this will keep tool safe and reliable.
•
Do not flush the tools or put it in water, it will cause short circuit or damage the device.
•
Keep ventilation, motor and handle cleaning, always use feather clean the device. Do not use
cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
•
After continuous work for 8 hours, please open the trigger cover protection of the equipment and
clean up wood chips and other impurities