User Manual
OBM-LT
10
4.
INSTRUCTIONS
FOR USE
4.1 Basic setup
Step 1:
Remove rubber cap and fill the bath with appropriate fluid (up to 80%)
Step 2:
Connect the power cord into the power supply 230V±10%; 50Hz
Step 3:
Put the main switch in position 1 (on the back of the device)
Step 4:
Press
button and
in
Program Start Menu
select the desired program. After selection press
button to start cycle
Step 5:
Check the fluid level and add if necessary
Step 6:
Press
button to stop the cycle
4.2 Control panel with OLED display and keyboard
START button
ESC button
STOP button
OLED display
Increase value button
Decrease value button
Navigate right button
Navigate left button
Navigate down button
Navigate up button
ENTER button
MENU button
