Note: always keep to a minimum the protruding (I) part of the b
(saw)
lade
d
• Once the part of the "no-protected" part of the blade has been
adjusted to assure a safe operation, tighten the lever (G) or the
screw, when present).
5.1.3 BLADEALLIGNMENT ADJUSTMENT
Note: In order to machine properly and accurately, the blade (I)
should be perfectly positioned at right angles, that is parallel to the
axes of the sliding rollers (L).
•In order to carry out the adjustment proceed as follows:
- Moderately loosen the two screws (M).
- Operate on the dowels (grub -screw) (N) until the blade is in
perfect vertical position.
- Tighten the screws (M).
5.1.4 ADJUSTMENT OF THE CLAMP
• Loose the knob (O).
• Slide the rode (P) according to the length of the piece to be cut
then lock the knob (O).
• Lock the piece to be cut by the vice against the piece locking ro
(P) and firmly tighten the lever (Q) of the vice.
5.2 SETTING THE CUTTING SPEED
• Set the blade speed according to the material to be cut, acting
on the adjusting device (R).
5.2.1 CUTTING SPEED
MATERIAL
m/rnin.
Stainless steel
20-50
Copper, aluminum and its alloys
50-80
Steel, etc.
80+110
Plastic materials
Содержание EV 91DHMV
Страница 7: ......
