Control and function
Regular breaks during operation are essential to maximise the life of this device as it is not designed for continual
use. Always unplug the unit from the mains when it is not being used for long periods or before servicing. In the
event of serious operation problems, stop using the unit and contact your dealer immediately.
Operation
(via the Mode button on the front of the unit)
Use the Mode button on the front of the unit to access the 3 operating modes available. Press the button to cycle
between the different modes. Please see below for a description of each function.
1. Auto plus Sound mode
(the LED indicator on the front of the unit will light orange)
The unit will run through the built-in patterns and programs unless there is any loud music or sound source and
then the lasers will flash and move to the beat of the music. It will automatically switch between Auto and Sound
modes dependent on whether there is an audio source. Either way, the unit will project laser light patterns.
2. Sound mode (Sound-to-Light)
(the LED indicator on the front of the unit will light green)
The unit’s lasers will respond to any loud music or sound source and will flash and move to the beat of the music.
The unit uses the built-in microphone to sense the music. The sensitivity of the microphone can be adjusted on the
remote control. If no loud audio is picked up by the microphone, the unit will STOP projecting laser patterns.
3. Auto mode
(the LED indicator on the front of the unit will light red)
The unit will run through the built-in patterns and programs, continually projecting laser light patterns.
ON/OFF
Press the Mode button a fourth time to turn to the unit OFF. To turn the unit ON, press the Mode button again.
Operation
(via IR remote control)
The wireless remote control overides any settings that are set using the Mode button on the unit.
To operate, point the remote at the unit (do not look at the unit, look at the patterns)
Press the
button to switch between
Auto plus Sound
and
Auto
modes.
Press the
button to pause the effect.
Press the
button to turn the unit
ON
or
OFF
.
Press the
–
or
+
buttons to adjust the microphone sensitivity to sound.
Press the
button to switch to
Sound
mode.
Press the
RED
button to display only the red laser patterns.
Press the
GREEN
button to display only the green laser patterns.
Press the
BLUE
button to display only the blue laser patterns.
Press the
RED/GREEN
button to display only the red and green laser patterns.
Press the
RED/BLUE
button to display only the red and blue laser patterns.
Press the
GREEN/BLUE
button to display only the green and blue laser patterns.
Press the
RED/GREEN/BLUE
button to display all 3 coloured laser patterns.
Press the
1
button to set the unit to
SLOW
rotation in
Auto
mode.
Press the
2
button to set the unit to
STEP-BY-STEP FAST
rotation in
Auto
mode.
Press the
3
button to set the unit to
FASTEST
rotation in
Auto
mode.
Press the
4
button to set the unit to
SLOW
rotation in
Auto plus Sound
mode.
Press the
5
button to set the unit to
STEP-BY-STEP FAST
rotation in
Auto plus Sound
mode.
Press the
6
button to set the unit to
FASTEST
rotation in
Auto plus Sound
mode.