Operating Mode
When the laser is powered on, the LCD monitor on rear panel shows the current operating standalone mode, DMX address or
Slave mode. With help of the LCD control panel, it is very easy to set and change the operating mode of the laser. The next time
the laser is powered on it will show the last setting used before the laser was powered off.
Mode Option, to choose the operating mode of laser.
Confirmation, to confirm the selected mode.
UP/DOWN, to change operating mode, parameter or DMX address.
Operation
Display
Stand alone mode pre-programmed effect
Aut
Automatic show with slow effect
Sou
Sound activated show
ATTENTION!
In pre-programmed standalone MUSIC SHOW mode, the laser beam will be blank-out in 3 seconds without
AUDIO/MIC activated signal.
Standalone Pre-program Laser Show
Press FUNC to enter MODE OPTION.
Use the up/down buttons to select either AUT or SOU.
Press UP or DOWN to select your favourite Standalone mode as above.
Press ENTER to confirm the setting.
The laser is working in stand alone. Each time when you turn on your laser, you will have this confirmed laser show.
AUTO SHOW
Each time when you turn on your laser, you will have this confirmed laser show.
SOUND ACTIVATED SHOW
Each time when you turn on your laser, you will have this confirmed laser show.
