Potential laser injury hazard exists with this product! Please read these instructions carefully, which include important information about
installation, safe use and service!
Caution
Avoid direct eye contact with laser light. Never intentionally expose your eyes or others to direct laser radiation.
Caution
This laser product can potentially cause instant eye injury or blindness if laser light directly strikes the eyes.
Caution
It is illegal and dangerous to shine this laser into audience areas.
Caution
It is illegal and dangerous to shine any laser at aircraft.
Caution
Operating procedures other than those specified herein may result in hazardous radiation exposure.
Overhead rigging
Important
- the installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and /or
damage to property. Overhead rigging required extensive experience. Working load limits should be respected, certified installation
materials should be used, the installed unit should be inspected regularly for safety.
l
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.
l
Locate the unit in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed
at least 50cm
from surrounding walls
l
The device should be installed out of reach of people and outside of areas where persons may walk by or be seated.
l
Before rigging make sure that the installation area can hold minimum point load of 10 times the device`s weight.
l
The device should be well fixed; a free swinging mounting is dangerous.
l
Do not cover any ventilation opening as this may result in overheating
Before first time use, the unit should be inspected for safety. Inspection the unit regularly every year.
AC power
The unit is supplied with a power plug appropriate to its voltage. Should any other connections be required they must be carried out with
the following configuration:
Cable (EU)
Cable (US)
Pin
International
Brown
Black
Live
L
Light blue
White
Neutral
N
Yellow/green
Green
Earth
DMX-512 connection
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a
DMX chain. If you wish to connect a DMX controller with other XLR outputs you will need to use adapter cables.
1 = shield
DMX output
2 = Signal (-)
DMX input
3 = Signal (+)
Connect the DMX output of the first unit in a DMX chain with the DMX input of the next unit in the chain. Always connect the the output of
one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5 pin to 3 pin adapter.
Caution
at the unit, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm resistor
between Signal (-) and Signal (+) into a 3-pin XLR connector and plug this into the DMX output of the
last unit in the chain.
